Rockford Tub ResurfacingRockford, IL

Tub Resurfacing Cost in Rockford, IL

Here is what this work actually runs in Rockford. We would rather put real numbers in front of you than make you ring round for three quotes to find out.

What tub resurfacing costs around Rockford

What the job involvesRockford price range per tub, or tub plus surround
Standard bathtub only$350 – $600
Fiberglass or acrylic tub with repairs$300 – $1,000
Tub plus tile surround$800 – $1,200
Full bathroom: tub, surround and vanity top$1,200 – $2,200

A tub-only reglaze averages near $450, with porcelain around $475 and cast iron $350 to $600. Adding the tile surround typically adds $400 to $600 depending on the tile area. Prices assume a sound tub; rust-through at the drain or a previously failed refinish adds prep. Most shops will quote from photographs but confirm on arrival.

What moves the price up or down

Tub material

Cast iron, porcelain-over-steel, fiberglass, acrylic and cultured marble each need a different prep sequence and primer. Fiberglass in particular flexes, which changes the coating choice and the risk.

Condition and prior coatings

A tub that has been refinished before is the expensive case, because the old coating has to be stripped completely first. Rust-through at the drain means metal repair before any coating.

How much surround is included

Tub only, tub plus the wall tile, or the whole bathroom including the vanity top are three very different jobs. Tile roughly doubles the sprayed area on a standard alcove.

Color change versus match

Standard white and biscuit are stock. Matching an existing unusual color, or a custom tint, adds material cost and sometimes an extra coat for coverage.

Access and ventilation

A small interior bathroom with no window needs more containment and forced-air exhaust than one with an operable window, which adds setup time to the quote.

Add-ons

Slip-resistant bottom treatment, new drain and overflow trim, and re-caulking are commonly quoted separately. So is chip repair beyond a stated allowance.

What should be in an estimate

When one quote comes in far under the others, it is worth asking what has been left out. Usually it is the preparation — and that is the part that decides whether the work lasts or fails early.

  • What coating system do you use, and is it a two-part product or a single-component one?
  • How do you etch the existing glaze, and how long does that step take on my tub?
  • Has this tub been refinished before, and if so is stripping included in the price?
  • How long until I can run water, and how long until normal daily use?
  • What is the warranty, how long does it run, and what voids it?
  • How will you ventilate the room, and what should I do about pets and family during the work?

Those are the questions we would ask if we were hiring someone, so ask them of us too. We will answer all of them in writing.

Get a free quote

Tell us what you need. We will come look at it and put a price in writing – no charge, no pressure.

Give us a phone number or an email so someone can reach you. Not for emergencies — call 911.

Where these figures come from

We publish our sources so you can check them.

Want a number for your job?

Free estimate, in writing, no pressure.

Tap to call (779) 335-0290